1.A connecting hyperlink of an O-ring Chain for standard application is pre-coated with grease on the pins. Ahead of connection, confirm the grease on the surfaces of pins, and in case the level of grease is little, apply grease with bare hands. (If gloves are applied, the grease might be absorbed through the gloves.)
Illustration: When the connecting hyperlink (I) of an O-ring chain for basic application is
shipped, O-rings are fitted on the roots on the pins. If the O-rings come loose because of vibration in the course of transport, refit the O-rings in to your roots from the pins.
In this case, make sure you return the grease collected on the roots on the pins for the central surfaces of your pins, much more at portion A than at portions B shown from the above illustration. (Portions A is worn as a result of sliding together with the bushings.)
2.The chain could be most quickly linked within the teeth of the sprocket. Engage the links at both ends on the chain together with the sprocket teeth and fit connecting pins. In case the sprocket is usually moved, the chain may also be connected within the loosened side.
three. Connecting process
one.Confirm that O-rings are connected for the roots of your pins.
two.If your volume of grease utilized on the connecting pins is tiny, coat the pins with grease on the central portions.
three.Insert the connecting pins to the bushings of the inner backlinks at each ends.
four.Confirm the grease is utilized to the whole face with the O-ring, and match the O-ring onto the connecting pins.
five.Insert the connecting pins in to the connecting plate and when pressing the connecting plate, install the spring clip. Verify no matter whether the head (the finish without a split) in the spring clip is turned from the feeding route on the chain. (See the following illustration.)
six.Be sure you confirm that the spring clip is securely fitted from the clip grooves on the connecting pins.
This completes jointing of your connecting website link. Note that grease about the surfaces of connecting pins and O-rings is often removed through set up perform. In this case, re-grease applying the grease on the surface in the base chain or even the grease within the polyethylene bag through which the connecting link was contained.