Materials Dealing with Energy UNIT 1
This energy unit is designed for that fork lift industry, consisting of remarkably efficient gear pump, DC motor, guide raise and reduce valve, tank, ect. The up and down movement are controlled through the lever from the guide release valve, which can be equipped with an electric switch to activate the motor. The lowing pace is controlled by the stress compensated movement manage valve.
1. The duty of this electrical power unit is S3, i.e. 30 seconds on and 270 senconds off.
two. Clean all the hydraulic elements concerned before installation of the power unit.
3. Viscosity on the hydraulic oil shoud be 15~46 cst, which must also be clean and free of charge of impurities, N46 hydraulic oil is suggested .
four. Oil modifying is needed right after the original a hundred operation hrs, afterwards once each 3000 hours.
five. The electrical power unit shown is made to be mounted horizontally.
Material Managing Power UNIT two
This power unit attributes energy up gravity down circuit. Activate the begin solenoid to begin the motor to lift the machine. The lowing motion is activated by the solenoid valve using the lowering pace managed through the stress compensated flow control valve. Products of this series might be broadly utilized in the industry of logistic devices such as fork lift, mini lift table, etc.
one. The duty of this electrical power unit is S3,i.e.,30 seconds on and 270 senconds off.
2. Clean the many hydraulic elements concerned prior to mounting the power unit.
3. Viscosity of your hydraulic oil shoud be 15~46 cst,which must also be clean and no cost of impurities, N46 hydraulic oil is advisable .
4. Oil changing is needed following the initial a hundred operation hours,afterwards when every 3000 hours.
five. The electrical power unit needs to be mounted horizontally.