Electrical power UNITS FOR LIFT TABLE one
General Description
This electrical power unit is developed solely for the little lift table,Consisting of high stress gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This electrical power unit has been widely employed from the marketplace of logistic gadgets like minifork lift, scissors lift and ariel doing work platforms. The lower-ing movement is controlled from the solenoid valve using the velocity managed through the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE two
Basic Description
This electrical power unit is built exclusively for that medium lift table, Consisting of remarkably effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering motion is actived through the solenoid valve plus the speed managed from the adjustable needle valve. When the lift rises to a high positoin, however the power supply is minimize, the lowering movement is managed through the guide override perform.
Power UNITS FOR LIFT TABLE 3
Basic Description
This power unit is made exclusively to the significant lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived through the solenoid valve and the speed managed by a pressure compensated flow handle valve.
Energy UNITS FOR LIFT TABLE four
General Description
This power unit is created exclusively to the large lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived by the solenoid valve as well as the velocity managed through the adjustable needle valve. When the lift rises to a high positoin, but the power supply is reduce, the decreasing motion is controlled from the manual override perform.
Special Notes
1. This power unit is of S3 duty cycle, which can only operate intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
two. Clean each of the hydraulic elements concerned before set up of the power unit.
3. Viscosity in the oil shoud be 15~46 cst,which need to also be clean and totally free of impurities.N46 hydraulic oil is suggested.
4. Oil shifting is required immediately after the original 100 operation hrs,afterwards as soon as just about every 3000 hours.
five. The power unit shown is designed to be mounted vertically.